Removing The Cr Motor - Epson Perfection V700 Photo Service Manual

EPSON Perfection V700 Photo
4.2.7

Removing the CR Motor

1. Remove the Carriage Unit.
2. Disconnect the CR Motor Connector from the CR Motor Relay
Connector.
3. Remove the C.B.P. M3 x 10 screw and C.B.P. M3 x 8 screw that
secure the FFC Cover and remove the FFC Cover.
4. Remove the C.P.F.P. M3 x 8 screw that secures the Harness B Cover
and remove the Harness B Cover.
5. Remove the two C.B.P. M3 x 10 screws, C.B.P. M3 x 10 screw and
C.P.F.P. M3 x 8 screw that secure the Motor Harness Cover.
6. Disconnect the CR Motor Relay Connector (CN9) from the Main
Board and remove the Motor Harness Cover.
7. Remove the C.B.P. M3 x 10 screw that secures the CR Motor Unit.
8. Remove the CR Drive Belt from the Driven Pulley and remove the
CR Motor Unit.
Disassembly / Assembly
See Section 4.2.6 on page 48.
CR Drive Belt
Motor Harness Cover
CR Motor Relay Connector (CN9)
C.B.P. M3x10 (7±1 kgf.cm)
C.B.P. M3x8 (7±1 kgf.cm)
C.P.F.P. M3x8 (7±1 kgf.cm)
Figure 4-27. Removing the CR Motor Unit
Disassembly Procedure
Driven Pulley
CR Motor Connector
FFC Cover
Positioning Hole and Guide Pin
Ferrite Core Locking Tab
Revision A
CR Motor Unit
Harness B Cover
50