Shutting Down The Server - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

4.2

Shutting down the server

V
CAUTION!
For further safety information, please refer to chapter
information" on page
I
This step is only required when upgrading or replacing non-hot plug
components.
Ê Inform the system administrator that the server will be shut down and put
offline.
Ê Terminate all applications.
Ê Verify if your backup software solution requires preparative configuration
before starting the procedure as described in section
configuring the backup software solution" on page
Ê In case of Multipath I/O environments, please refer to section
server maintenance in a Multipath I/O environment" on page
Ê Remove all backup and optical disk media from backup and optical disk
drives as described in section
page 136.
Figure 8: On / Off button on the front panel
Ê Shut down the server.
I
If the system is running an ACPI-compliant operating system,
pressing the On / Off button will perform a graceful shutdown.
Ê Switch on the ID indicator on the front and rear connector panels of the
server as described in section
TX300 S7 / RX350 S7
47.
"Removing backup and optical disk media" on
"Locating the defective server" on page
Upgrade and Maintenance Manual
Basic hardware procedures
"Important
"Verifying and
136.
"Note on
137.
60.
67