Hard disk drives / solid state drives
7.5.2
Removing the SAS expander board
7.5.2.1
Required tools
Preliminary and concluding steps: tool-less
●
Removing the SAS expander board: tool-less
●
7.5.2.2
Preliminary steps
Before removing the SAS expander board, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê Shut down the server as described in section
page
67.
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
from the mains" on page
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Open the side / top cover as described in section
on page 75
(rack server) or
server).
Ê Pull out the ID card and open the front cover as described in section
"Opening the server" on page
Ê Remove the air duct as described in section
on page
92.
Ê Remove the system fan holder as described in section
system fan holder" on page
Ê Remove all cables from the SAS expander board.
364
133.
68.
"Extending the server out of the rack" on page
"Removing the side cover" on page 84
75.
378.
Upgrade and Maintenance Manual
"Disabling BitLocker
"Shutting down the server" on
"Disconnecting the server
73.
"Removing the top cover"
"Removing the system air duct"
"Removing the
TX300 S7 / RX350 S7
72.
(tower