Removing The 3.5-Inch Hdd Bay Top Cover - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Hard disk drives / solid state drives
Ê Remove the system fan holder as described in section "Removing the
system fan holder" on page 378.
Ê Disconnect all cables from the defective SAS backplane.
7.3.9.3

Removing the 3.5-inch HDD bay top cover

Figure 156: Removing the 3.5-inch HDD bay top cover (A)
Ê Remove five screws from the 3.5-inch HDD bay top cover (see blue arrows).
Ê Remove one screw from the intrusion switch holder (see orange arrow).
Upgrade and Maintenance Manual 275
TX300 S7 / RX350 S7