Hard disk drives / solid state drives
7.2.7.2
Preliminary steps
Before replacing a 2.5-inch HDD / SSD module, perform the following steps:
Ê Locate the defective server as described in section
server" on page
Ê When working on a tower server, open the HDD bay cover as described in
section
"Removing accessible drive and HDD bay covers" on page
Ê Locate the defective HDD / SSD module as described in section
diagnostic indicators on the front" on page
Only applicable for removing intact HDD / SSD modules:
Ê Before removing a non-defective HDD / SSD module, put the drive into
"Offline" mode using your RAID configuration software.
7.2.7.3
Removing a 2.5-inch HDD / SSD module
Ê Remove the HDD / SSD module to be replaced from the server as described
in section
"Removing a 2.5-inch HDD / SSD module" on page
7.2.7.4
Installing a 2.5-inch HDD / SSD module
Ê Install the new HDD / SSD module into the empty drive bay as described in
section
"Installing 2.5-inch HDD / SSD modules" on page
7.2.7.5
Concluding steps
Perform the following procedures to complete the task:
Ê When working on a tower server, close the HDD bay cover as described in
section
"Installing accessible drive and HDD bay covers" on page
Ê Please observe the notes on RAID rebuild in section
array rebuild" on page
216
60.
157.
Upgrade and Maintenance Manual
"Locating the defective
63.
206.
"Performing a RAID
TX300 S7 / RX350 S7
87.
"Local
212.
111.