Accessible drives
12.6.3 Replacing the slimline ODD or LSD
Upgrade and Repair Units (URU)
Average task duration: 10 minutes
12.6.3.1 Required tools
Preliminary and concluding steps: tool-less
●
Replacing a slimline ODD or LSD:
●
– Slotted screw driver (for bending in or out accessible drive mounting
brackets)
12.6.3.2 Preliminary steps
Before replacing a slimline ODD or LSD, perform the following steps:
Ê Locate the desired server as described in section
server" on page
Ê Remove all backup and optical disk media from backup and optical disk
drives as described in section
page
136.
Ê Shut down the server as described in section
page
67.
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
from the mains" on page
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Open the side / top cover as described in section
on page 75
(rack server) or
server).
676
60.
"Removing backup and optical disk media" on
68.
"Extending the server out of the rack" on page
"Removing the side cover" on page 84
Upgrade and Maintenance Manual
"Locating the defective
"Shutting down the server" on
"Disconnecting the server
73.
"Removing the top cover"
TX300 S7 / RX350 S7
72.
(tower