Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

14.5.1 Required tools

Preliminary and concluding steps: tool-less
●
Replacing the system board:
●
– Phillips PH2 / (+) No. 2 screw driver
Replacing the system board:
●
– Magnifying glass for inspecting CPU socket springs (recommended)
If a TPM module is installed:
– Bit screw driver
– TPM bit insert
– thin slotted screw driver (2 x 0.4 mm)
( )
* For the Japanese market:
– Dedicated TPM screw driver (CWZ8291A)
– TPM module fixing tool (S26361-F3552-L909)

14.5.2 Preliminary steps

Before replacing the system board, perform the following steps:
Ê Ensure to note down your current network settings in the operating system.
For further information, please refer to section
recovery" on page
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê Disable boot watchdog functionality as described in section
SVOM boot watchdog functionality" on page
Ê Locate the desired server as described in section
server" on page
Ê Shut down the server as described in section
page 67.
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
from the mains" on page
Ê Disconnect all external cables.
TX300 S7 / RX350 S7
( )
*
796.
133.
60.
68.
Upgrade and Maintenance Manual
System board and components
( )
*
"Note on network settings
"Disabling BitLocker
134.
"Locating the defective
"Shutting down the server" on
"Disconnecting the server
"Disabling
797