Concluding Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Figure 120: Installing the intrusion switch holder (B)
Ê Secure the intrusion switch holder on the HDD bay top cover with one
M3 x 4.5 mm screw.
7.2.8.8

Concluding steps

Perform the following procedures to complete the task:
Ê Reinstall the system fan holder as described in section
fan holder" on page
Ê Reinstall the air duct as described in section
on page 94.
Ê Close the front cover and reinstall the ID card as described in section
"Closing the server" on page
Ê Install HDD / SSD modules or HDD dummy modules into the additional HDD
slots as described in sections
page 208 and
page 214.
I
For detailed information on HDD mounting order, refer to section
inch HDD / SSD configurations" on page
TX300 S7 / RX350 S7
379.
104.
"Installing a 2.5-inch HDD / SSD module" on
"Installing a 2.5-inch HDD / SSD dummy module" on
Upgrade and Maintenance Manual
Hard disk drives / solid state drives
"Installing the system
"Installing the system air duct"
191.
"2.5-
233