Checking Gpgpu Operation - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

9.4.1.10 Checking GPGPU operation

Ê Switch on the server as described in section
page 131.
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
Ê Open the side / top cover as described in section
on page 75 (rack server) or
server).
Figure 294: Cabling the GPGPU card
Ê Ensure that the LEDs on the rear side of the GPGPU card are lit green,
indicating sufficient power supply.
Ê If the LEDs are lit red, shut down the server, remove power cords from the
PSU modules and recheck the GPGPU power cabling.
TX300 S7 / RX350 S7
"Extending the server out of the rack" on page
"Removing the side cover" on page 84
Upgrade and Maintenance Manual
Expansion cards and backup units
"Switching on the server" on
"Removing the top cover"
72.
(tower
461