Page 50
8.2
Play Channel Controls
After recording to disk, you can play back any of the recorded files. The bottom section
of the Play screen
the filename for each channel to be played back, set the recording transfer length, start
and stop the recording, and monitor the status of the recording.
8.2.1
8.2.2
8.2.3
Rev.: 1.0
(Figure
8−2) contains the play controls . This section lets you enter
Figure 8−2: Play Screen: Channel Controls
File Name and Browse
The name of the file to be played back is entered in the text entry window
under File Name adjacent to the appropriate resource. Alternately, you can
click on the Browse button to locate a file using a file directory window. The
extension of the played file must be .dat. The full path, including the drive
letter, must be included with the file name.
Start Position
The starting position of the playback file in seconds or megasamples can be
entered in the numeric entry window under Start Position. If the Start
Position equals 0.0 secs or 0 MSs, then the playback starts at the beginning
of the file. If the Start Position exceeds the length of file in time, then an
error message appears: <servername>: File too small
Play Until Manual Stop
You can choose to play a signal until the Stop button is pressed, by entering
a file transfer length or file transfer time of 0 in the Transfer Length field.
NOTE:
If you don't manually press Stop, playback will stop automatically
at the end of the file.
Talon RTX 2767 Operating Manual