Table 5−1: Clock Parameters - Pentek Talon RTX 2767 Operating Manual

Page 28
5.7 Configuring the Talon System Using the Configuration Panel (continued)
5.7.2
Parameter Selection
Clock Internal
Source
External
<user entry> MHz
Clock
Frequency
<user entry> MHz
Reference
Clock <user entry> MHz
Frequency
A/D Clock
drop down menu
selection
Divider
D/A Clock
drop down menu
selection
Divider
A/D
Sampling
Rate
D/A
Sampling
Rate
Rev.: 1.0
Configuring Clock Parameters (continued)
Table 5−1: Clock Parameters
Uses the internal VCXO (voltage−controlled crystal oscillator).
Uses the externally supplied clock to the CLK SSMC connector
If you selected Internal for Clock Source, you must enter the
internal VCXO clock frequency in MHz.
If you selected External for Clock Source, you must enter the
external clock frequency in MHz.
Enter a reference clock frequency: typically 10 MHz.
Divides the VCXO or external clock to provide a Channel 1 input
clock rate.
Divides the VCXO or external clock to provide a Channel 1 output
clock rate.
Displays the Channel 1 input clock rate calculated based on the
Channel 1 input clock divider you specified.
Displays the Channel 1 output clock rate calculated based on the
Channel 1 output clock divider you specified.
Talon RTX 2767 Operating Manual
Description