Table of Contents
Advertisement
Talon RTX 2767 Operating Manual
6.3
Master Record Controls (continued)
6.3.7
6.3.8
6.3.9
6.3.10
Master Current Position (Secs)
The current recording position within the file is shown in seconds. When the
recording is stopped manually or automatically, the Current Position field
displays the total duration of the recording.
Record GPS Position
This check box determines whether the GPS position is recorded. By default,
Talon recording systems that have the GPS option will automatically record
the GPS position (write it to the header file). However, if you do not want
the Talon system to record this information, simply uncheck this check box.
When you save a profile, the state of this check box will be saved, so you can
set this option as enabled or disabled beforehand. If your system does not
have the GPS option, this box will not appear on the record screen.
Signal Viewer
The Signal Viewer button launches the Talon Signal Viewer for preview or
monitoring of the signals before or during recording. See
details.
Programmable Recording Start Time
The SystemFlow software allows you to set a date and time at which record−
ing will start automatically, thus eliminating the need for someone to start
the recorder manually.
Flow Record screen. When you specify a time in this field and put a check
mark in the Enable checkbox, recording will start automatically at the time
you specified.
Figure 6−4: Start Time
shows the Start Time field on the System−
Figure
Page 43
Chapter 9
for more
Rev.: 1.0
Advertisement
Table of Contents
