Talon RTX 2767 Operating Manual
6.2
Record Channel Controls (continued)
6.2.2
6.2.3
6.2.4
6.2.5
Overwrite
The software is designed to prevent you from overwriting existing record−
ings on disk. If you want to overwrite existing recordings, you must select
the Overwrite checkbox. If you select Overwrite, the system will not pre−
vent you from overwriting existing recordings nor will it provide any warn−
ing.
Be careful when selecting the Overwrite checkbox and remember that if you
save a profile with the Overwrite checkbox selected, the profile will main−
tain this setting whenever you use it.
Record Until Manual Stop
You can choose to record a signal until you manually press the Stop button
by entering a file Transfer Length or file transfer time of 0.
NOTE:
If you don't manually press Stop, recording will stop automati−
cally when the disk is filled.
Record by Time
To record for a period of time, specify the number of seconds for the record−
ing using the numeric entry field under Transfer Length. This entry accepts
a floating point value, allowing you to specify resolutions smaller than 1
second. After the recording starts, it will automatically stop after the elapsed
time specified.
NOTE:
The minimum record time is 1 millisecond.
NOTE:
If the Transfer Time is greater than the total free disk space, the
recording will stop when the disk is filled.
Record by File Size
To record for a specific number of MSs, specify the number of megasamples
for the recording using the numeric entry field under Transfer Length. After
the recording starts, it will automatically stop after the file size reaches the
specified limit.
NOTE:
The minimum recording time is 1 millisecond. If the number of
MSs represents a record time of under 1 millisecond, you will be
prompted accordingly.
NOTE:
If the Transfer Length is greater than the total free disk space, the
recording will stop when the disk is filled.
Page 37
Rev.: 1.0