Tips For Using The Gps Expansion Pod - Juniper Allegro CE Owner's Manual

After the settings have been selected, tap on the Apply Settings button
to save the new settings. Tap on the Get Settings button to bring up
the GPS pods current settings to double check them.
Reviewing and Editing the Receiver Parameters
Once you determine which data format you are going to use, follow
these steps to review and edit the parameters as needed:
1. Click on the Get Settings button to reset the parameters to their
default setting.
2. Change the parameters, if necessary, by clicking on the down
arrow on the right of the Baud, Parity, Stop Bits, and/or GPS Data
Format box to bring up a list of setting options, and click on the
setting you want.
3. Click on the Apply Settings button.
4. Click on the X in the top right corner to Exit out of the program.
▲ ▲ ▲ ▲ ▲

Tips for Using the GPS Expansion Pod

Keep the following tips in mind while using the Allegro with the GPS
expansion pod:
1. When attempting to receive GPS signals, get the clearest view of
the sky as possible. Obstructions such as buildings, trees,
mountains, and your body can keep signals from reaching the
receiver.
2. Do not cover the antenna with anything while you are using the
system.
3. The antenna can be mounted on a vehicle or a pole, a longer cable
is required to do this. Contact our Sales Department for details.
4. Using the GPS expansion pod, and GPS or GIS software running
on the Allegro may cause the Allegro battery to drain at a faster
rate. This rate depends on the software and how much processing
is taking place.
Page 8-8 Expansion Pods