Unsuccessful Connection; Establishing Additional Activesync Connections - Juniper Allegro CE Owner's Manual

A screen on the desktop PC that says Connecting is shown. The New
Partnership: Set Up a New Partnership appears. Proceed to the Setting
Up a Partnership section of this chapter.
❖ Note: If you are having problems with the Allegro connecting to the
desktop PC while using the USB connection, perform a reset on the Allegro
and repeat the USB connection process.
An Unsuccessful Connection
If the connection was not successful, the following screen appears on
the PC:
From here, click on the Next button on the Your device was not
detected screen and the Getting Connected screen appears again.
Repeat the connection instructions for the COM port you are using
until a successful connection is made.
▲ ▲ ▲ ▲ ▲

Establishing Additional ActiveSync Connections

If you already have ActiveSync installed on your desktop PC,
complete the following steps for connecting the Allegro to the desktop
PC. These instructions are also designed for all additional
connections to between the Allegro and desktop PC using ActiveSync.
You do not need to set up the communication settings each time, as
described in Establishing a First Time Connection Using ActiveSync.
1) Turn on the Allegro and the desktop PC.
2) Connect the communication cable to the ports you set up on each
computer during the file transfer program installation process.
Windows CE Page 4-77