For More Information; Gps Antenna Removal - Juniper Allegro CE Owner's Manual

5. The PC card slot is accessible while the GPS expansion pod is
attached to the Allegro. In the Allegro User's Manual, refer to
Section 2, Hardware Features, PC Card Slot for details on how to use
it. There is a flat, brown flex cable that is part of the expansion
pod that you will see when you open the pod door. Do not twist,
bend, or break this cable while you are using the PC card slot.
6. If you remove the antenna, place the protective cap over the
antenna connector to keep dirt and moisture out.
▲ ▲ ▲ ▲ ▲

For More Information

Your GPS is now configured correctly to use the GPS pod. If you have
any questions or still cannot connect, please contact your reseller or
our technical service department at (435) 753-1881, or by email at
techsupport@junipersys.com.
▲ ▲ ▲ ▲ ▲

GPS Antenna Removal

The antenna takes the place of the mini-stylus in the top of your
Allegro. It is shipped already attached to Allegro but depending on
your needs, can be removed and replaced. To remove the GPS
antenna from your Allegro, complete the following steps:
1. Unscrew the antenna cable from the Allegro expansion pod.
2. Loosen the thumbscrews on the antenna so that the antenna and
the two knobs at the end of the antenna clamp are no longer
securely fastened.
3. Pull the antenna off of the Allegro.
The antenna can be returned to the Allegro by reversing the previous
instructions.
Expansion Pods Page 8-9