Table of Contents
Advertisement
Bolt tightening torque:
37 N·m (3.7 kgf·m, 27 lb·ft)
EMU26263
Trim rod (tilt pin)
The position of the trim rod determines the
minimum trim angle of the outboard motor in
relation to the transom.
EMU30531
Tilt lock mechanism
The tilt lock mechanism is used to prevent
the outboard motor from lifting out of the wa-
ter when in reverse gear.
1
1. Tilt lock lever
To lock it, set the tilt lock lever in the lock po-
sition. To release, push the tilt lock lever in
the release position.
EMU32711
Tilt support lever for hydro tilt model
To keep the outboard motor in the tilted up
position, lock the tilt support lever to the
clamp bracket.
ECM00661
ZMU03177
Do not use the tilt support lever or knob
when trailering the boat. The outboard
motor could shake loose from the tilt sup-
port and fall. If the motor cannot be
trailered in the normal running position,
use an additional support device to se-
cure it in the tilt position.
EMU26374
Cowling lock lever(s) (turn type)
To remove the engine top cowling, turn the
cowling lock lever(s) and lift off the cowling.
When installing the cowling, check to be sure
it fits properly in the rubber seal. Then lock
the cowling again by returning the cowling
lock lever(s) to the lock position.
ZMU07436
Components
ZMU03179
25
Advertisement
Table of Contents
