Chapter 2 Printer Operation
Setting the Media
Sensor Selection Method
(Transparent Reflective) (p.55)
Adjusting the Transparent sensor
(p.56)
Adjusting the Reflective sensor
(p.57)
6. Setting sensor positions
When using a transparent sensor
Move the bottom sensor close to the center of the width of the media,
then align the upper sensor marker and the bottom sensor marker
(white) using the movable media guide.
When using media that is 4 inches wide, position the upper sensor
and the bottom sensor all the way to the right (large blue-head open
lever side).
Upper sensor marker
Aligned with the marker
Transparent
sensor marker
When using a reflective sensor
Adjust the position of the sensor so that the reflective sensor marker
of the bottom sensor is at the center of the black mark of the media
as shown below.
Media
Bottom sensor
Black mark
Platen
* When using a reflective sensor, install the upper sensor in such a
manner that the upper sensor marker is not in the same position
of the reflective sensor marker. Paper end detection may be
impossible if installation is not done in this manner.
28
Bottom sensor
Platen
Front
Re ective sensor marker
Front
Upper sensor
Movable
media guide
Black mark