Citizen CL-E700 Series User Manual page 41

Chapter 2 Printer Operation
Mode Settings
Menu Setting Table
Page Setup Menu - allows you to change settings related to the media or print quality.
System Setup Menu - allows you to change settings for the printer hardware and basic control systems.
After Print Menu - changes how the printer reacts after the label has been printed.
Interfaces - changes interface parameters such as baud rate.
Option Interfaces - communication settings of Option Interfaces.
Machine Information, Test Mode - allows you to check and/or print test pages and information about the
printer.
Global Config menu - allows you to switch between 3 complete 'config sets' contained within the printer.
Press the MENU key in print possible status to enter MENU Setup Mode. Use the keys on the operation panel
according to the LCD display to setup the printer. The contents that can be setup on the printer are shown
below. And the items that are actually displayed on the LCD are shown in [ ].
 For Datamax® Emulation
Top Menu Sub Menu
Page Setup Print Speed
Print Darkness
Darkness Adjust
[Darkness Adj]
Print Method
Continuous Media
Length
[Cont Media Len]
Vertical Position
[Vertical Pos]
Horizontal Position
[Horizontal Pos]
Vertical Image Shift
[Vertical Image]
Auto Side Shift
Media Sensor
Small Media
Adjustment
[Small Media Adj]
Small Media Length
[Small Media Len]
Symbol Set
Default Menu
6 IPS 2 to 8 IPS
10 00 to 30
00 -10 to 10
TT TT
DT
4.00 inch 0.25 to 158.00 inch
101.6 mm 6.4 to 4013.2 mm
0.00 inch -1.00 to 1.00 inch
0.0 mm -25.4 to 25.4 mm
0.00 inch -1.00 to 1.00 inch
0.0 mm -25.4 to 25.4 mm
0.00 inch 0.00 to 32.00 inch
0.0 mm 0.0 to 812.8 mm
00 dot 00 to 15 dots
See Through See Through
Reflect
Non
Off On
Off
1.00 inch 0.25 to 1.00 inch
25.4 mm 6.4 to 25.4 mm
PM 50 symbols
41
Remarks
Printing speed setting.
(7 or 8 IPS only in Direct Thermal mode.)
(2 to 6 IPS with optional peeler.)
Adjusting print darkness.
Fine adjustment of darkness commands.
Selecting thermal transfer (ribbon) /direct
thermal media.
Setting media length of continuous media.
Lower level = during mm mode.
Adjusting printing start position.
Adjusting horizontal image position.
Adjust the off set value in vertical when
mapping data on a RAM.
Allows horizontal shifting of printing
position by specified number of dots per
page.
Effective when load is applied to a specific
head area, like vertical lines.
Selecting media sensor.
Setting for small media
Setting media length for small media.
Setting symbol set.