Citizen CL-E700 Series User Manual page 43

Chapter 2 Printer Operation
Mode Settings
[Datamax® Emulation]
Top Menu Sub Menu
After Print Auto Configure
[Auto Config]
Function Select
[Function Sel]
Cutter Action **
Peel Wait Delay *
Paper Position
Menu Key Action
* Only when peeling option is mounted.
** Only when cutter is mounted.
Default Menu
On On
Off
Tear Off
Tear
Peel On *
Cut On **
Backfeed Backfeed
Through
0.1 sec 0.1 to 2.0 sec
0.00inch Peel/Cut/Tear Off
0.00mm 0.00 to 2.00 inch
0.0 to 50.8 mm
Peel/Cut/Tear On
-1.00 to 1.00 inch
-25.4 to 25.4 mm
Enters Menu Repeat Last Set
Repeat Last One
Enters Menu
43
Remarks
Automatically configures optional devices.
On .....AutoConfigure enabled (Regardless
of whether Function Select is set, if
a peeler or cutter is installed, each
mode is set automatically.)
Off ....AutoConfigure disabled (A peeler of
cutter is installed, but to not operate
the peeler or cutter, turn it Off and
the operation is selected by Function
Select.)
Selects the operation when the
AutoConfigure is set to Off.
Designates the paper position based on
each option. The operation of this device is
enabled during selection.
At the same time, the parameters of the f
command of Prodigy Plus are emulated for
each optional device.
Cutter operating method setting
Backfeed: it feeds back after each cutting
operation.
Through: when the number copied = n, the
back end of sheet 1 to n-1 passes through,
and the back end of the final page that is a
single sheet is copied and fed back.
Sets the Peel Wait Delay.
Displays only machines with a peeler
installed.
Adjusts the stop position. It is based on the
inch/millimeter setting. There are initial
values of the stop position for each device
set above, and later, relative values are set.
Sets the menu key action.
Repeat Last Set:
Repeats the number of copies.
Repeat Last One:
Last one is issued only for the final page.
In the case of a count, afterwards, only
last one is issued.
Enters Menu:
Enters the menu setup mode.
Note: Hold down the MENU key for at least
4 seconds in order to enter the Menu Setup
Mode when setting the "Repeat Last Set" or
"Repeat Last One" menus.