Citizen CL-E700 Series User Manual page 56

Chapter 3 Printer Adjustments
Sensor Adjustments
Installing the Media (p.26)
Sensor Selection Method
(Transparent  Reflective)
(p.55)
Adjusting the Transparent sensor
1. The transparent sensor is selected.
2. Install only the liner media (label backing paper) with the
label media removed so that it will pass between the platen
roller and the media sensor. (Be careful that media with
black marks does not pass the media sensor.)
Upper sensor
Bottom sensor
3. If the Pause key is pressed then released while the Feed key
is continually pressed, the sensor is automatically adjusted.
Sensor Cal Mode
Executing
4. When automatic adjustment stops normally, "Succeeded" is
displayed by the LCD. If it stops abnormally (adjustment is
impossible), the LED lights up red and "Failed" is displayed on the
LCD.
5. If the Stop key is pressed, the printer completes sensor
adjustment and the printer restarts.
56
Label
Media gap
Liner media
Hold
Sensor Cal Mode
Succeeded
Press/Release