Citizen CL-E700 Series User Manual page 44

Chapter 2 Printer Operation
Mode Settings
[Datamax® Emulation]
Top Menu Sub Menu
Interfaces USB Device Class
[USB Device Clas]
USB VCOM Protocol
[VCOM Protocol]
USB 2.0 High Speed
[USB Hi Speed]
IPv4 Address
IPv4 Subnet Mask
[IPv4 Subnet]
IPv4 Gateway
IPv4 DHCP
IPv6
Option RS-232C Baud
Interfaces
RS-232C Parity
RS-232C Length
RS-232C Stopbit
RS-232C X-ON
IEEE1284 *
Web Monitor *
* If the parallel board or multi-function LAN board is mounted.
Note: Settings related to interface are enabled after restart or after power is connected again.
Default Menu
Printer Printer
VCOM
Auto Auto
DTR
X-ON
On On
Off
169.254.001.010 000.000.000.000 to
255.255.255.255
255.255.000.000 000.000.000.000 to
255.255.255.255
000.000.000.000 000.000.000.000 to
255.255.255.255
On On
Off
On On
Off
9600 115200
57600
38400
19200
9600
4800
2400
None None
Odd
Even
8 bits 8 bits
7 bits
1 bit 1 bit
2 bits
Yes Yes
No
On On
Off
Auto Auto
On
Off
44
Remarks
Selects the USB device class.
Selects the protocol (flow control) when
operating USB VCOM.
Enable/disable setting of USB2.0 High
Speed.
When disabled, device runs at Full Speed.
Set of IPv4 Network Address
Set IPv4 Subnet Mask
Set IPv4 Gateway
IPv4 DHCP enable/disable setting
IPv6 enable/disable setting
Setting the baud rate of the serial interface.
• All settings related to the interface are
enabled after the power is reconnected.
Setting the communication parity for the
serial interface
Setting the character length for the serial
interface.
Setting the stop bit for the serial interface.
Selectively setting the X-ON flow control of
the serial interface.
Setting both direction of the Centro
Interface.
Selecting the web monitor function.