3.4 Adjusting Media Sensor Positions
This section describes the procedure to adjust sensors when loading media. Transmis-
sive and reflective sensors can be used for the media sensors.
The printer comes from the factory equipped with a transmissive sensor. The media
sensor must be replaced with a reflective sensor for certain types of media.
Range of Paper Sensor Adjustment
The following figure illustrates the range of media sensor adjustment.
Left fixed media guide
(Moval scope of transport sensor)
6.0 to 26.0 mm
2.5 mm
Left margin
118 mm (Max. media width)
(Moval scope of reflective sensor)
6.0 to 74.0 mm
Dimension of
media feed
CL-E321:104.0 mm
CL-E331:105.0 mm
Printable area
49
—
—
Refer to 7.1 Sensor Adjustment Mode
CL-E321:11.5 mm
CL-E331:10.5 mm
Right margin