Citizen CL-E700 Series User Manual page 48

Chapter 2 Printer Operation
Mode Settings
[Zebra® Emulation]
Top Menu Sub Menu
Keyboard Lock
LCD Standby
Standby Timer
Media Power Up
CI Lock
Emulation Select
[Emulation Sel]
Emulation Auto
Detect
[Emulation Auto]
After Print Auto Configure
[Auto Config]
Function Select
[Function Sel]
Cutter Action **
* Only when peeling option is mounted.
** Only when cutter is mounted.
Default Menu
Off On
Off
Off On
Off
5min 1 to 99min
Off On
Off
Off On
Off
ZPI2 DM4
DMI
DPP
ZPI2
Full Auto On
Off
Full Auto
On On
Off
Tear Off
Tear
Peel On*
Cut On**
Backfeed Backfeed
Through
48
Remarks
Prevents a change by a key operation.
Hold down the Menu Key for at least 4
seconds to enter the Menu Setup Mode
when setting the "On" menu.
When the LCD Standby setting is turned
ON, the LCD display will turn off in standby
mode.
You can set the time it takes for the
machine to go into Standby Mode.
Selects whether or not to initiate media
measurement when the power in ON.
Activates/deactivates the CI command.
Selects DataMax®/Zebra® compatibility
DM4: DataMax® 400
DMI: DataMax® IClass
DPP: DataMax® Prodigy Plus®
ZPI2: Zebra® ZPL2®
Selects the detection of Datamax® and
Detect Off Zebra® emulation.
Automatically configures optional devices.
On .....AutoConfigure enabled (Regardless
of whether Function Select is set, if
a peeler or cutter is installed, each
mode is set automatically.)
Off ....AutoConfigure disabled (A peeler of
cutter is installed, but to not operate
the peeler or cutter, turn it Off and
the operation is selected by Function
Select.)
Selects the operation when the
AutoConfigure is set to Off.
Designates the paper position based on
each option. The operation of this device is
enabled during selection.
At the same time, the parameters of the f
command of Prodigy Plus are emulated for
each optional device.
Sets the cutter action.
With the optional AutoConfigure On,
printing is executed only when the cutter
is installed or only when Cut is selected by
Function Select.
Backfeed is always set after cutting.
Through is set at the rear end of sheets
1 to n-1 when the number of copies = n,
and the rear end of the final page of single
sheet and the copy is backfeed.