Citizen CL-E700 Series User Manual page 51

Chapter 2 Printer Operation
Mode Settings
[Zebra® Emulation]
Top Menu Sub Menu
Machine Model Number
Information
Boot Version
[Machine Info]
ROM Version
ROM Date
ROM CheckSum
FPGA Version
Head Check
Print Counter
Service Counter
Cut Counter
Sensor Monitor
Option Interface
[Option I/F]
RS-232C Baud
RS-232C Parity
RS-232C Length
RS-232C Stop bit
RS-232C X-ON
MAC Address
Test Mode Print Pattern
Head Check
Factory Default
Hex Dump
Serial Monitor
Auto Calibration
[Auto Cal]
Sensor Monitor
Global –
configuration
[Global Config]
Note:To restore factory default settings, turn on printer power while pushing the Feed and Pause keys simultaneously, then press
the MENU key and the Stop key sequentially.
Default Menu
– CL-E***
– *.*
– ********
– **/**/**
– ****
– *.*
– OK
NG
– ****.*** km
– ****.*** km
– *******
– *.* V
– None
RS-232C
LAN
IEEE1284
– –
– –
– –
– –
– –
– –
Current Config Current Config
Global Config
Sample
No Yes
No
No Yes
No
No Yes
No
– –
See Through See Through
Reflect
See Through See Through
Reflect
Config Set 1 Config Set 1
Config Set 2
Config Set 3
51
Remarks
Displays the model name.
Displays the boot version
Displays the ROM version.
Displays the date the ROM was prepared.
Displays the check sum of the ROM
Displays the FPGA version
Displays the results of the head check.
Displays the print counter.
Displays the service counter.
Displays the cut count.
Displays the sensor level.
Displays the presence/absence of the
optional interface.
• If Dip Switch 1 is ON in RS-232C interface,
RS-232C (DIP SW) will be displayed. (See
"Interface" in the section of Appendix)
If Dip Switch 1 is ON in RS-232C interface,
the communication condition set in Dip
Switch will be displayed.
Displays MAC Address
Executes the test pattern.
Executes head check.
Initializes the set values of the configuration
set to the state when the unit was shipped
from the factory.
Sets the hex dump mode.
Displays the state of the serial interface.
Executes the calibration of the sensor.
Displays the level of the sensor.
Sets the Config Set.