Head Restraints - Skoda Yeti 2015 Operating Instructions Manual

Hide thumbs Also See for Yeti 2015:
Table of Contents

Advertisement

WARNING
The front passenger airbag should be switched off when transporting ob-
jects on the seat which was folded forwards
front passenger airbag.
Adjust the seat backrest only when the vehicle is stationary.
When moving the seat backrest, make sure the seat backrest has been
properly secured – check by pulling on the seat backrest.
If the seat backrest is folded, passengers may only be transported on the
outer seat behind the driver.
When moving the seat backrest, keep limbs out of the area between the
seat and seat backrest – risk of injury!
Never transport the following items on the seat backrest when folded
forwards.
Objects that could restrict the driver's view.
Objects which make it impossible for the driver to control the vehicle,
e.g. if they roll under the pedals, or could protrude into the driver's zone.
Objects which could lead to injury to passengers due to a change of di-
rection or braking manoeuvre when accelerating sharply.

Head restraints

Introduction
This chapter contains information on the following subjects:
Adjusting, installing and removing the headrests.
Rear centre head restraints
WARNING
The following guidelines must be observed
ed position.
Note
The position of the front and rear outer head restraints is adjustable in height.
The middle rear head restraint is only adjustable in two positions.
82
Using the system
» page
20, Deactivating the
82
83
» page
8, Correct and safe seat-
Adjusting, installing and removing the headrests.
Fig. 65 Head restraint: Move up / move down
Read and observe
on page 82 first.
Setting the height
Grasp the restraint and move upwards in the direction of
To move the restraint down, press the securing button
arrow
and hold while at the same time pressing the restraint in the direc-
2
tion of arrow
.
3
Removing/installing
Pull the head restraint out of the seat backrest as far as the stop.
Press the locking button
in the direction of the arrow
A
the head restraint out.
To re-insert the head restraint, push it far enough down into the seat back-
rest until the locking button clicks into place.
» Fig.
65.
1
in the direction of
A
» Fig. 65
and pull
2

Advertisement

Table of Contents
loading

Table of Contents