Skoda Yeti 2015 Operating Instructions Manual page 208

Rear Light
Fig. 203 Remove light / pull out connector

Read and observe and
Removing
›
Open the boot lid.
›
Use the screwdriver from the tool kit
the lamp » Fig. 203.
›
Grasp the light and carefully remove with shaky movements in the direction
of arrow » Fig. 203.
1
›
Disconnect the plug connection by pressing the catches in direction of arrow
and by pulling them in direction of arrow
2
Fitting
›
Insert the connector into the light and lock it securely.
›
Insert the light into the mounts in the body
›
Carefully press the light into the body so that the bolts
page 205 or » Fig. 205 on page 205 on the light engage into the mounts on
the body.
›
Screw the light with the screws into place
on page 202 first.
» page 183, Vehicle tool kit to unscrew
.
3
» Fig. 203.
» Fig. 204
1
» Fig. 203.
Replacing bulbs in rear light
Fig. 204 Inner part of the light: Ground light
Fig. 205 Inner part of the light: Light with LED diodes

Read and observe
on
Ground light
›
With the spanner from the vehicle tools unscrew the securing screw
» Fig. 204.
›
Unlock the bulb holder using the locking latches in the areas
marked with arrows and remove the bulb holder from the light.
›
Turn the respective bulb
from the bulb holder.
›
Insert a new bulb
stop.
›
Pull bulb out of the socket and insert a new bulb.
C
›
Insert the bulb holder in the light.
The lamp holder must engage audibly.
and on page 202 first.
until it stops counter-clockwise and remove it
B
into the holder and turn in a clockwise direction to the
B
Fuses and light bulbs
A
» Fig. 204

205