Table of Contents
Advertisement
Adjusting the ready position
Fig. 145 Lock unlock / pull out hand wheel and turn
Read and observe
and
The tow bar must be set to the ready position prior to
Correctly set ready position.
If not in the ready position, it must be set to the ready position as follows.
›
Grip the tow bar below the protective cap.
›
Remove the cap from the lock
›
Insert the key into the hand wheel lock.
›
Turn the key
in direction of the arrow
A
›
Pull the handwheel
in the direction of the arrow
B
tion of the arrow
to the stop.
3
The hand wheel
remains locked in this position.
B
144
Driving
on page 143 first.
installation» page
to the stop
» Fig.
145.
1
and drag in the direc-
2
Correctly set ready position
Fig. 146 Ready position
Read and observe
144,
Correctly adjusted standby position
The locking balls
The red marking
B
tow bar.
The key
is in the unlocked position and cannot be removed.
C
There is a clear gap of approx. 5 mm
tow bar.
The ball bar is thus set ready for installation.
CAUTION
When in the ready position, the key cannot be removed from the handwheel
lock.
and
on page 143 first.
» Fig. 146
can be pushed fully into the tow bar.
A
on the hand wheel is located in the green box on the
between the hand wheel and the
D
Advertisement
Chapters
Table of Contents
