Rear centre head restraints
Fig. 66 Rear centre head restraint: Removal / installation
Read and observe
on page 82 first.
Applies to vehicles using the TOP TETHER system.
Removing/installing
›
Pull the head restraint out of the seat backrest as far as the stop.
›
Press the locking button
in the direction of arrow
A
the same time using a flat screwdriver with a max. width of 5 mm to press
the securing button in opening
›
Remove the restraint in the direction of arrow
›
To re-insert the head restraint, push it far enough down in the direction of
arrow
into the seat backrest until the locking button clicks into place.
4
Rear seats
Introduction
This chapter contains information on the following subjects:
» Fig. 66
1
in the direction of arrow
.
B
2
.
3
Setting theSetting the seats in the longitudinal direction
›
Pull lever
in the direction of arrow
A
sition in the direction of arrow
inclination of the seat backrest
, while at
Fig. 68 Adjusting the seat backrest
›
Pull lever
on the lower portion in the direction of arrow
A
›
Adjust the desired inclination of the seat back in the direction of arrow
WARNING
83
Check for yourself that the seat backrest is engaged by pulling on it.
83
84
84
85
85
Fig. 67
Adjusting seats in forward/back
direction
and move the seat to the desired po-
1
» Fig.
67.
2
» Fig.
1
Seats and head restraints
68.
2.
83