Skoda Yeti 2015 Operating Instructions Manual page 151

If the trailer that is to be towed has a 7-pin connector, you can use a suitable
adapter from ŠKODA Original Accessories to establish a connection to the elec-
tricity.
›
Hook the breakaway cable of the trailer onto the safety eyelet
The breakaway cable of the trailer has to sag when mounted into the security
lock slot for all trailer positions relative to the vehicle (sharp curves, reverse
driving and the like.)
Uncoupling
›
Unhook the breakaway cable of the trailer from the safety eyelet
» Fig. 153.
B
›
Unplug the trailer cable from the 13-pin socket.
›
Remove the trailer from the ball head.
›
Place the cap » Fig. 144 on page 143onto the ball head.
5
›
Grip the 13-pin socket at point
arrow » Fig. 153.
Exterior mirrors
You have to have additional exterior mirrors fitted if you are not able to see
the traffic behind the trailer with the standard rear-view mirrors. The national
legal requirements must be observed.
Headlights
The front of the vehicle may lift up when a trailer is being towed and the head-
lights may dazzle other road users.
Adjust the headlights using the headlight beam control
range control  .
1)
WARNING
Improperly connected trailer electrical installations may cause accidents
■
or serious injury due to electric shock.
Work on the electrical system must only be carried out by specialist ga-
■
rages.
Never directly connect the trailer's electrical system with the electrical
■
connections for the tail lights or other current sources.
After coupling the trailer and connecting up the power socket, check the
■
rear lights on the trailer to ensure they are working.
1)
Applies to vehicles with xenon headlights.
148
Driving
and swing in the opposite direction to the
A
» page 66, Headlight
WARNING (Continued)
The handbrake on the towing vehicle must be applied when coupling and
■
uncoupling the trailer.
Never use the safety eyelet for towing!
■
.
B
CAUTION
Improperly connected trailer electrical installations may cause malfunction of
the entire vehicle electronics.
Loading a trailer
The vehicle/trailer combination must be balanced, whereby the maximum per-
missible drawbar load must be utilised. If the drawbar load is too low, it jeop-
ardises the performance of the vehicle/trailer combination.
Distribution of the cargo
Distribute the cargo in the trailer in such a way that heavy items are located as
close to the trailer axle as possible. Secure the items from slipping.
The distribution of the weight is very poor if your vehicle is unladen and the
trailer is laden. Maintain a particularly low speed if you cannot avoid driving
with this combination.
Tyre pressure
Correct the tyre inflation pressure on your vehicle for a "full load"
Towing capacity and trailer weight
The permissible trailer load must not be exceeded under any circumstances
» page 207, Technical data.
The details given in the vehicle's technical documentation always take prece-
dence over the details in the Owner's Manual.
The trailer loads specified apply only to altitudes up to 1 000 metres above
mean sea level.
The engine output falls as altitude increases, as does the vehicle's climbing
power. Therefore, for every additional 1000 m in height (or part), the maximum
permissible towed weight must be reduced by 10%.
The towed weight is made up of the actual weights of the loaded towing vehi-
cle and the loaded trailer.
» page 177.
