Table of Contents
Advertisement
Window lifter buttons
» Fig. 41
Left front door
A
Right front door
B
Left rear door
C
Right rear door
D
Disable / enable the buttons in the rear doors
E
Opening
›
Lightly press the appropriate button down and hold it until the window has
moved into the desired position.
Releasing the button causes the window to halt immediately.
The window can be completely opened automatically by briefly pressing the
button as far as the stop. Renewed pressing of the button causes the window
to stop immediately.
Closing
›
Pull gently on the top edge of the corresponding button and hold until the
window has moved into the desired position.
Releasing the button causes the window to halt immediately.
The window can also be fully closed automatically by pulling the button up to
the stop. Renewed pulling of the button causes the window to stop immedi-
ately.
Disable / enable the buttons in the rear doors
›
Press the button
» Fig.
41.
E
When the buttons are disabled in the rear doors, the warning light in the
button
lights up.
E
WARNING
The system is fitted with a force limiter
■
cle, the closing process is stopped and the window goes down by several
centimetres. However, the windows should be closed carefully – risk of in-
jury.
If the rear seats are accommodating people who are not completely inde-
■
pendent, e.g. children, it is recommended that for safety reasons the but-
tons in the rear doors are disabled with the button
62
Using the system
» page
63. If there is an obsta-
.
E
CAUTION
Keep the windows clean to ensure the correct functionality of the electric
■
windows.
In the winter, ice accumulating on the surface of the window may cause
■
there to be more resistance when closing the window. The window will stop
and move back several centimetres.
It is necessary to deactivate the force limiter to close the window
■
» page
63.
Always close the windows before disconnecting the battery.
■
Note
After switching the ignition off, it is still possible to open or close the win-
■
dows for approx. 10 minutes. After the driver's or front passenger's door has
been opened, the windows can only be operated by using button
The window lift mechanism is equipped with protection against overheating.
■
Repeated opening and closing of the window can cause this mechanism to
overheat. If this happens, it will not be possible to operate the window for a
short time. You will be able to operate the window again as soon as the over-
heating protection has cooled down.
Opening the windows in the front passenger door and in the rear
doors
Read and observe
and
There is a button in the front passenger door and in the rear doors for that
window.
Opening
›
Lightly press the appropriate button down and hold it until the window has
moved into the desired position.
Fig. 42
Power window button
on page 61 first.
» Fig.
41.
A
Advertisement
Chapters
Table of Contents
