Table of Contents
Advertisement
WARNING
The national legal regulations for using mobile communication devices in
■
a vehicle must be observed.
Do not fit the equipment or mounts to be connected to airbag covers or
■
within the immediate deployment range of the airbags.
Never leave a connected device in the deployment area of an airbag, on a
■
seat, on the dash panel or any another area, from which it can be thrown
during a sudden braking manoeuvre, an accident or a collision - risk of in-
jury.
CAUTION
ŠKODA accepts no responsibility for any problems caused by incompatibility or
improper functioning of the communication equipment and the applications.
Note
The ŠKODA applications, support communications devices with the Android
■
operating system version 4.x.x and later and iOS 7.x.x and higher.
With SmartGate, a device can be connected to two ongoing ŠKODA applica-
■
tions, possibly two devices, each with a respective current ŠKODA application.
If you have forgotten your password for the connection to SmartGate, Smart-
■
Gate must be reset to factory settings in a specialised workshop.
Connection to SmartGate using Wi-Fi
Read and observe
and
For a successful connection the following conditions must be met.
Wi-Fi is turned on in the device to be connected.
The ignition is switched on.
Connection set-up
›
Can enable the connected device to search for available Wi-Fi networks (see
operating instructions for the connected device).
›
In the menu of the detected networks select "SmartGate_..."
SmartGate_..."
.
1)
›
Enter the password (the password is pre-set at the factory to the complete
Vehicle Identification Number - enter capital letters).
1)
The last six symbols of the VIN vehicle identification number of your vehicle are displayed at position ....
52
Using the system
on page 52 first.
or "DIRECT
1)
Disconnection
The connection can be switched off in one of the following ways.
›
By disconnecting the connected device from SmartGate.
›
By turning off the Wi-Fi in the connected device.
›
By switching off the ignition for more than 5 s (for vehicles with starter but-
ton - by turning off the engine and opening the driver's door).
Automatic connection
If the communication device once had a connection with SmartGate, then the
connection is automatically restored under the following conditions.
Wi-Fi is turned on in the device to be connected.
The ignition is switched on.
The device to be connected stores the password required for the connec-
tion check.
Connection using Wi-Fi direct to SmartGate
Read and observe
and
This type of connection is provided for communication devices and applica-
tions that support connection via Wi-Fi Direct.
Connection set-up
›
Switch on the ignition.
›
In the device to be connected start the ŠKODA application that supports con-
nection via Wi-Fi Direct.
›
In the application, select the connection function (e.g. "Connect"), this starts
to search for available devices that support Wi-Fi Direct.
›
In the menu of the detected networks select from the menu "SmartGate_..."
›
Enter the PIN code (the factory default setting for the password is the last
six digits of the vehicle identification number).
If you want to connect to SmartGate from another vehicle, then after the start
of the application, disconnect the previous connection by selecting the separa-
tion function (e.g. "Disconnect ").
on page 52 first.
.
1)
Advertisement
Chapters
Table of Contents
