Printhead Removal - Lexmark 363dn Service Manual

7013-XXX

Printhead removal

1.
Remove the top cover. See
2.
Remove the right side printer cover. See
3.
Disconnect the two cables (A) from J12 and J8 on the controller board, and unroute them back through the
frame toward the printhead.
4.
Remove the three screws (B).
Note: Use a pencil to mark the screw locations of the printhead on the metal frame. Align the new printhead
relative to the location of the old printhead. See
5.
Remove the printhead.
4-66
Service Manual
"Top printer cover removal" on page
"Right side printer cover removal" on page
A
"Printhead assembly mechanical adjustment" on page
B
4-76.
4-71.
3-24.