Precautions; Installation - Toshiba e-studio 55 Operator's Manual For Copying Functions

Digital plain paper copier
Hide thumbs Also See for e-studio 55:
Table of Contents

Advertisement

PRECAUTIONS

1. INSTALLATION

1
The e-STUDIO55/65/80 should be installed by a qualified service technician.
Note: The packing material should be disposed of properly.
2
To obtain the best possible results, this copier should be used in conjunction with a
dedicated AC power line at the following ratings:
230 – 240V, 50/60 Hz, 9 A
Notes:
1. The use of other appliances or other equipment on the same line as this copier may adversely
affect performance and copy quality.
2. Be sure to use a 3-conductor, grounded wall outlet.
3. In areas where a 2-pin plug is used, the copier must be grounded for safety.
Never ground it to a gas pipe, a water pipe, or any other object not suitable for grounding.
3
After a suitable place has been selected for the installation of the e-STUDIO55/65/80,
please do not change it. Avoid excessive heat, dust, vibration and direct sunlight. Also,
provide proper ventilation as the copier emits a small amount of ozone.
Notes:
1. The recommended environmental range for use is as follows:
• Temperature:
• Humidity:
2. To insure optimal operation, allow clearances of at least 80 cm on the left, 80 cm on the
right and 10 cm in the rear (refer to the illustration below).
The socket-outlet shall be installed near the equipment and shall be easily accessible.
10~30˚C/50~86˚F
20~85% RH
80 cm
10 cm
80 cm
5

Advertisement

Table of Contents
loading

This manual is also suitable for:

E-studio 80E-studio 65

Table of Contents