Table of Contents
Advertisement
PRECAUTIONS
1. Installation
1
The e-STUDIO211c/311c should be installed by a qualified service technician.
1
Note: The packing material should be disposed of properly.
2
To obtain the best possible results, this copier should be used in conjunction with a
dedicated AC power line at the following ratings.
2
115V–60Hz, 16A
Notes:
1. The use of other appliances or other equipment on the same line as this copier may adversely
3
affect performance and copy quality.
2. Be sure to use a 3-conductor, grounded wall outlet.
3. In areas where a 2-pin plug is used, the copier must be grounded for safety.
Never ground it to a gas pipe, a water pipe, or any other object not suitable for grounding.
4
3
After a suitable place has been selected for the installation of the e-STUDIO211c/311c,
please do not change it. Avoid excessive heat, dust, vibration and direct sunlight. Also,
provide proper ventilation as the copier emits a small amount of ozone.
5
Notes:
1. The recommended environmental range for use is as follows:
• Temperature:
• Humidity:
6
2. To insure optimal operation, allow clearances of at least 32" on the left, 32" on the right and 4" in
the rear (refer to the illustration below).
7
8
9
10
11
The socket outlet should be installed near the equipment and be easily accessible.
12
8
10~30°C/50~86°F
20~85% RH
Advertisement
Table of Contents
