ADJ 9.5 Toner Cartridge Home Sensor
Purpose
The purpose is to set the Toner Cartridge Home Sensor to the correct distance from the mag-
net on the Toner Cartridge.
Switch off the Main Power Switch. Disconnect the Power Cord.
Check
1.
Remove the Developer Module (
REP
2.
Remove the Cartridge Drive Plate (
3.
(
Figure
1): Check that the tip of the Toner Cartridge Home Sensor is 2.5 0.5 mm from
the plate.
Toner Cartridge
Home Sensor
Figure 1 Checking the Position of the Toner Cartridge Home Sensor
Adjustment
1.
Perform the check.
NOTE: The Toner Cartridge Home Sensor is threaded. The wires must be disconnected and
straightened in order to rotate the sensor for adjustment.
8825/8830 Printer
WARNING
9.5).
REP
9.14).
2.5 +/- 0.5 mm
01/02
4-113
Repairs and Adjustments
ADJ 9.5