REP 8.8 Media Registration Sensor
Parts List on
PL 8.2
Switch off the Main Power Switch. Disconnect the Power Cord.
NOTE: The art used for this procedure was developed for previous products and may not
match the 8825/8830 configuration exactly.
Removal
1.
Latch the Xerographic Module at the Service Position
2.
Remove the Media Transport Assembly
3.
(Figure
1): Remove the Media Registration Sensor.
Repairs and Adjustments
REP 8.8
WARNING
(REP
9.2).
(REP
8.1).
3
Remove the two screws and the Media Registration Sensor
2
Remove the two screws
and the assembly
Figure 1 Removing the Media Registration Sensor
01/02
4-30
Sensor Window
1
Push down the tab and
disconnect the connector
8825/8830 Printer