Xerox 8825 Service Manual page 87

Parts List on PL 7.2
Switch off the Main Power Switch. Disconnect the Power Cord.
Removal
1. Loosen the screws and open the Rear Door.
2. Remove the Rewind Clutch (REP 7.6).
3. (Figure 1): Remove the Encoder Disk.
1
Remove the Encoder
Figure 1 Removing the Encoder Disk
Replacement
1. Reinstall the Motion Sensor and the Rewind Housing.
8825/8830 Printer
WARNING
2. (Figure 2): Reinstall the Encoder Disk.
1
Align the open slot in the
Encoder Disk with the
opening in the housing
Figure 2 Reinstalling the Encoder Disk
01/02
4-19
3
Ensure that the slot in the
Encoder Disk aligns with
the pin in the shaft
2
Reinstall the
Encoder Disk
Repairs and Adjustments
REP 7.11