Adj 8.2 Lead Edge Registration - Xerox 8825 Service Manual

ADJ 8.2 Lead Edge Registration

Purpose
The purpose is to adjust the print media to the image on the drum for Lead Edge Registration
within specification.
Prerequisite
1. Check the following:
a. Fuser Temperature (NVM) ( ADJ
b. Vertical Magnification ( ADJ 8.1)
Check
1. Enter diagnostics.
2. Enter code [ 0955] and make four 210 mm prints of Test Pattern #7.
3. Allow the prints to cool for five minutes.
4. ( Figure 1): Using the last print, check that the distance from the lead edge to the first hor-
izontal line is 16.25 ± 2 mm.
Figure 1 Checking the Lead Edge Registration
Adjustment
1. Enter code [ 0860] in order to adjust the Lead Edge Registration.
2. ( Figure 2): Select the type of media. The following message is displayed. (In this exam-
ple, bond paper media has been selected.)
8825/8830 Printer
10.1)
Figure 2 Media Selection
NOTE: The range of adjustment is 0 to 20. Each step equals approximately 1 mm.
3. Adjust the Lead Edge Registration using the Previous / Next buttons.
a. Use the Previous button to decrease the Set Point, which will move the image
away from the lead edge.
b. Use the Next button to increase the Set Point, which will move the image closer to
the lead edge.
c. Press the Enter button in order to store the value in NVM.
d. Press the Exit button two times.
4. Repeat the check for all the types of media used by the customer.
01/02
4-99
Repairs and Adjustments
ADJ 8.2