Xerox 8825 Service Manual page 135

Disposal of the Pin Array is carefully controlled because it is made of a Beryllium Cop-
per alloy. Package the old Pin Array as a returned part. Also, be especially careful of
the very sharp tips on the Pin Array.
6. (Figure 3): Remove the Charge Scorotron Pin Array.
7. Remove the Torsion Springs from the End Blocks.
Replacement
1. Install the Torsion Springs from the repair kit.
Be careful not to damage the tips of the new Pin Array. Bent tips can cause Print Quality prob-
lems.
2. Install the Pin Array from the repair kit into the End Blocks.
3. Reinstall the End Blocks into the Scorotron Extrusion. Ensure that the Pin Array is posi-
tioned in the Center Support (not shown) of the Scorotron Extrusion.
4. After completing the reassembly, package the Pin Array for return.
8825/8830 Printer
WARNING
CAUTION
Torsion Spring
2
Pull the Pin Array and lift it
off the stud
Stud
Scorotron
Extrusion
Figure 3 Removing the Charge Scorotron Pin Array
01/02
4-67
1
Spread open the plastic extrusion
and lift out the End Block
4
Repeat Steps 1-3 at the
opposite end and remove
the Pin Array
3
Remove the Pin Array
from the tangs of the tor-
sion spring
Repairs and Adjustments
End
Block
Grid Channel
Grove
REP 9.8