Xerox 8825 Service Manual page 101

6. (Figure 1): Remove the Media Transport Drive Motor Assembly.
7. (Figure 2): Remove the motor from the mounting plate.
2
Remove the
screws (3)
3
Remove the
Motor Assembly
Figure 1 Removing the Motor
8825/8830 Printer
Replacement
1. Ensure that the belt is over the Idler Pulley.
2. (Figure
1
Disconnect the
connector
4
Remove the
mounting plate
Idler Pulley
01/02
4-33
2): If a new motor is being installed, use the Drive Pulley from the old assembly.
1
Remove the ground
wire and the screw
3
Remove the screws
and washers (3)
Figure 2 Removing the Media Transport Drive Motor Assembly
2
Remove the retaining
clip and the Drive Pulley
Repairs and Adjustments
REP 8.10