Rep 8.16 Exit Roll - Xerox 8825 Service Manual

REP 8.16 Exit Roll

Parts List on PL 8.4
Switch off the Main Power Switch. Disconnect the Power Cord.
Removal
1. Latch the Xerographic Module at the Service Position
2. Remove the Media Transport Assembly
3. Remove the Media Exit Switch (REP
4. (Figure 1): Remove the Exit Roll from the Front Pivot Assembly.
Repairs and Adjustments
REP 8.16
WARNING
(REP 9.2).
(REP 8.1).
8.2).
1
Remove the E-ring
Left Side
4
Remove the Exit Roll by moving it to the
right until it is free of the bushing on the
left side, then lift the roll out of the Front
Pivot Assembly
Figure 1 Removing the Exit Roll
01/02
4-40
3
Remove the E-ring
2
Remove the belt, the E-ring and
the pulley
Front Pivot
Assembly
Exit Roll
8825/8830 Printer