Rep 3.2 High Voltage Power Supply - Xerox 8825 Service Manual

REP 3.2 High Voltage Power Supply

Parts List on PL 1.3
Switch off the Main Power Switch. Disconnect the Power Cord.
Removal
1. Loosen the screws and open the Rear Door.
2. (Figure 1): Remove the High Voltage Power Supply.
Replacement
1. If a new High Voltage Power Supply is being installed, perform the Electrostatic Series
(ADJ 9.2).
8825/8830 Printer
WARNING
6
7
Disconnect J30
Pull the
HVPS off the
pins
8
Remove the three screws
(7 mm hex head)
Figure 1 Removing the High Voltage Power Supply
01/02
4-7
5
Disconnect the Grid wire
4
Disconnect the
Charge Scorotron
wire
3
Disconnect the Transfer
Corotron wire (small
connector)
2
Disconnect the
Detack Corotron wire
(large connector)
1
Disconnect A25P1
Repairs and Adjustments
REP 3.2