Rep 9.19 Roller Kit; Rep 9.20 Image Module - Xerox 8825 Service Manual

REP 9.19 Roller Kit

Parts List on PL 9.3
NOTE: These are the instructions to install Roller Kit 600K58740. The kit contains the following
items:
• Rollers (2)
• Pins (2)
Switch off the Main Power Switch. Disconnect the Power Cord.
Removal
1. Raise and secure the Top Cover.
2. Open the Image Module.
3. (Figure 1): Using pliers, pull out the pin and remove the roller.
Replacement
1. Replace the roller and pin with parts from the kit.
2. Repeat the procedure at the rear of the Image Module.
Roller
Figure 1 Removing the Front Roller
8825/8830 Printer
WARNING
Pin

REP 9.20 Image Module

Parts List on PL 9.3
NOTE: These are the instructions to install the Image Module Assembly Kit 600K58760. The
kit contains the following:
• Image Module Assembly
Switch off the Main Power Switch. Disconnect the Power Cord.
Removal
1. Remove the Developer Module
2. Remove the Developer Baffle
3. Remove the following:
a. Rear Door (PL 14.1)
b. Front Door (PL 14.2)
c. Right Side, Left Lower Cover
d. Right Side, Right Lower Cover
e. Right Side, Left Cover (three screws, two top, one bottom)
f. Right Side, Right Cover (three screws, one top, two bottom)
4. Remove the High Voltage Power Supply
NOTE: In the following steps, cut cable ties as necessary in order to remove the harness.
01/02
4-81
WARNING
(REP 9.5).
(PL 9.8).
(PL 14.2)
(PL 14.2)
(PL 14.2)
(PL 14.2)
(REP 3.2).
Repairs and Adjustments
REP 9.19, REP 9.20