1
Insert the short Extractor Tab through the window in the module connector
4.
(
Figure
4): Reform the Terminal Locking Tab.
8825/8830 Printer
Long Extractor Tab (working edge of tool)
1
Insert the long Extractor Tab through the window in the housing
Terminal removal through the housing
Short Extractor Tab (working edge of tool)
Terminal removal through the connector
Figure 3 Removing the Terminal from the Connector
2
Remove the terminal from the housing
01/02
6-51
(Terminal shown rotated 90
degrees)
2
Remove the terminal
(Terminal shown rotated 90
degrees)
General Procedures
Molex Connector Repair Procedure