Sharp MX-M264U Service Manual page 99

26-6
Purpose Setting
Function (Purpose) Used to set the specifications (paper, fixed
magnification ratio, etc.) of the destination.
Section
Operation/Procedure
1) Select an item to be set with the touch panel.
2) Press [EXECUTE] key.
The selected set content is saved.
U.S.A. United States of America
CANADA Canada
INCH Inch series, other destinations
JAPAN Japan
AB_B AB series (B5 detection), other destinations
EUROPE Europe
U.K. United Kingdom
AUS. Australia
AB_A AB series (A5 detection), other destinations
CHINA China
26-10
Purpose Setting
Function (Purpose) Used to set the trial mode of the network
scanner.
Section
Operation/Procedure
1) Enter the set value with 10-key.
2) Press [OK] key.
The set value in step 1) is saved.
TRIAL MODE 0
(0: YES 1: NO)
1
26-18
Purpose Setting
Function (Purpose) Used to set Disable/Enable of the toner
save mode operation.
(For the Japan and the UK versions.)
Section
Operation/Procedure
1) Select an item to be set with scroll keys.
2) Enter the set value with 10-key.
3) Press [OK] key.
The set value in step 2) is saved.
Item Display
A COPY 0 Copy toner save mode is inhibited.
1 Copy toner save mode is allowed
B PRINTER 0 Printer toner save mode is inhibited.
1 Printer toner save mode is allowed.
Trial mode setting
Trial mode cancel (Default)
Default
Content
value
MX-M264U SIMULATION 6 – 25
26-30
Purpose
Function (Purpose) Used to set the operation mode corre-
Section
Operation/Procedure
1) Enter the set value with 10-key.
0
1
2) Press [OK] key.
The set value in step 1) is saved.
* Even in Enable state, the control may not be executed due
to the power frequency, etc.
U.S.A 1 (CE not supported)
CANADA 1 (CE not supported)
INCH 1 (CE not supported)
JAPAN 1 (CE not supported)
AB_B 1 (CE not supported)
26-32
Purpose
Function (Purpose) Used to set the special functions.
Section
Operation/Procedure
1) Enter the set value with 10-key.
2) Press [OK] key.
The set value in step 1) is saved.
Item/Display
A CLEANING
PRINT SET
26-35
Purpose
Function (Purpose) Used to set the display mode of SIM 22-4
0
Section
Operation/Procedure
0
1) Enter the set value with 10-key.
0
1
2) Press [OK] key.
The set value in step 1) is saved.
Setting
sponding to the CE mark (Europe safety
standards). (For slow start to drive the fus-
ing heater lamp)
Control allowed
Control inhibited
EUROPE
U.K.
AUS.
AB_A
CHINA
Setting
Content Setting range
The screen of the 0
cleaning mode self print
execution is displayed.
(ON)
The screen of the 1
cleaning mode self print
execution is not
displayed. (OFF)
Setting
trouble history when a same trouble
occurred repeatedly. There are two display
modes: display as one trouble and display
as several series of troubles.
Only once display.
Any time display.
0 (CE supported)
0 (CE supported)
0 (CE supported)
0 (CE supported)
0 (CE supported)
Default
value
YES 1(NO)
NO