Sharp MX-M264U Service Manual page 19

Mode
Exit tray setting
Insertion of job separator sheet
Staple function of received data
Auto wake up print
*1
Received data print hold
Color toner print when black toner
runs out.
*1: This function saves all received data in memory and starts out
put after password entry. (Confidential reception is excluded.)
Setting only on the reciver side.
(7) Report/list function
Mode
Image sending activity report
Transaction report
Address/phone number table
Group table
Program table
Memory box table (F code)
Communication original contents
print
List of allowed or rejected
reception numbers
Table of control record for each
account
(8) Other Functions
Mode
Time specification
Polling reception
Bulletin board transmission
Cover sheet function
Transmission message
Sender print
Sender selection
Page number print
Date print
Polling protection function
Page partition transmission
Page connection
Confidential (receiver unit)
Relay broadcast instructions
*1
Fax to e-mail (F code)
Edge erase
Center erase
2 in 1
Card shot
Forward data transmission/
reception (Document Admin)
*1: This function means that e-mail address setteing on F code
relay broadcast allowed.
FAX
Yes
No
Yes
Yes
Yes
No
FAX
Yes
Time-specified output
Output with memory full
* Maximum of 200 times including
both transmission and reception
Yes
Yes
Yes
Yes
Yes
Always print/Upon error/no print
Yes
No
FAX
Yes
Yes
Yes
Up to 100 registrations allowed with
bulletin board, confidential and relay
broadcast all combined. (Free area :
1 registration)
Setting of the number of
transmission: 1/no limit.
No
No
Yes
Yes
Yes
Yes (Date can be expressed
alternatively)
Yes
Yes
No
Yes (F code method)
Yes (F code method)
Yes
Yes
Yes
Yes
Yes (Equivalent or enlargement up to
the paper width. The maximum
enlargement is not allowed to exceed
400%)
Yes
Data transmission by PC-Fax/
PC-Internet Fax is allowed, too.
MX-M264U SPECIFICATIONS 2 – 10
(9) Transmission Method
Mode
Transmission time 2 seconds level (super G3/JBIG),
6 seconds level (G3 ECM)
Automatic fall-back : 33.6kbps  2.4kbps
Modem speed
Intercommunication Super G3/G3
Communication line General membership telephone line
(PSTN), independent business line
(PBX), F net.
(R-key for PBX setting: Germany/France)
ECM Yes
(10) Record Size
Mode
Maximum record width
Record size
(11) F code communication
Mode
Sub-address
Password
(12) Registration-related settings
Mode
*1
One-touch/group
E-mail
FTP
Desktop
SMB
FAX
Program
Number of memory boxes
Number of sender registration
Number of sender selection
registration
Registration of polling approval
number
Registration of Fax system
number (Sharp mode)
Registration of Fax polling
approval ID number (Sharp mode)
Fax relay ID registration (Sharp
mode)
*2
Quick key (short cut registration)
Import/export of address book
Black list (for France)
*1: Since scan/Internet Fax/Fax uses the common address book,
the number of addresses allowed for registration is the sum
total of all modes.
*2: Quick key is the function to select an address based on the
registered number of each address within the book for address
selection. Users should be able to select a quick key number.
FAX
FAX
293mm
A3 – A5/11" x 17" – 5.5" x 8.5"
FAX
Yes (20 digits)
Yes (20 digits)
FAX
1000 destinations
Use of LDAP allowed
Up to 500 registered addresses for
each group dial.
Registered name in 18 full-size
character (36 half-size characters)
One-touch dial receiver number
registration: within 64 digits for
receiver number + sub-address +
passcode (including "/").
Registration of addresses (groups),
settings (density, image quality) and
special functions in one set is
allowed. (48 of them)
Registration of bulletin board/
confidential/relay broadcast is
allowed up to 100.
Registration name: 18 characters
1 (default) with 20 characters
Total: 18 registrations (20 characters)
(Sender selection: In addition to
default, 18 registrations allowed)
10 numbers/20 digits
No
No
No
Yes (001 – 1000)
Yes (By storage backup)
No