Sharp MX-M264U Service Manual page 132

50-10
Purpose Adjustment
Function (Purpose) Used to adjust the black print image magni-
fication ratio and the off-center position.
(The adjustment is made separately for
each paper feed section.)
Section
Operation/Procedure
1) Select an adjustment target item with scroll key on the touch
panel.
2) Enter the set value with 10-key.
3) Press [EXECUTE] key. (The set value is saved.)
Item/Display
A MAIN-MFT Print off center adjustment value (Manual paper feed)
B MAIN-CS1 Print off center adjustment value (Tray 1)
C MAIN-CS2 Print off center adjustment value (Tray 2)
D MAIN-CS3 Print off center adjustment value (Tray 3)
E MAIN-CS4 Print off center adjustment value (Tray 4)
F MAIN-ADU Print off center adjustment value (Duplex)
CAUTION:
G SUB-MFT Registration motor ON timing adjustment
H SUB-CS12
I SUB-DSK
J SUB-ADU
K MULTI COUNT Number of print
L PAPER MFT Tray selection
CS1
CS2
CS3
CS4
M DUPLEX YES Duplex print selection
NO
Item A - F: When the adjustment value is increased, it is shifted to the front frame side. When the adjustment value is decreased, it is shifted to
the rear frame side. 1 step = 0.1mm change
50-12
Purpose Adjustment
Function (Purpose) Used to perform the scan image off-center
position adjustment. (The adjustment is
made separately for each scan mode.)
Section
Operation/Procedure
1) Select an adjustment target item with scroll key on the touch
panel.
2) Enter the set value with 10-key.
3) Press [OK] key. (The set value is saved.)
When the adjustment value is increased, the image position is
shifted to the rear frame side. When the adjustment value is
decreased, it is shifted to the front frame side.
1step = 0.1mm
Item/Display
A OC
B SPF (SIDE1)
C SPF (SIDE2)
Content
If the adjustment items A - F are not properly adjusted,
this adjustment cannot be executed properly.
Manual paper feed
Standard cassette
DESK
ADU
Manual paper feed
Tray 1
Tray 2
Tray 3
Tray 4
Yes
No
Content
Document table image off-center adjustment
SPF front surface image off-center adjustment
SPF back surface image off-center adjustment
MX-M264U SIMULATION 6 – 58
Setting range Default value
1 - 99 50
1 - 99 50
1 - 99 50
1 - 99 50
1 - 99 50
1 - 99 50
1 - 99 50
1 - 99 50
1 - 99 50
1 - 99 50
1 - 999 1
1 - 5 1 2 (CS1)
2
3
4
5
0 - 1 0 1 (NO)
1
Setting range
1 - 99
1 - 99
1 - 99
NOTE
Adjustment Item
List
Adjustment pattern
print conditions
setting
Default value
50
50
50