Snmp Configuration (Optional) - Fujitsu XG0224 User Manual

XG Series User's Guide
3.1.3

SNMP Configuration (Optional)

To operate in conjunction with an SNMP manager, the SNMP agent must be configured.
To configure the SNMP agent, carry out the following procedures in "admin" Operation mode.
XG2600# configure
XG2600(config)# snmp service on
XG2600(config)# snmp agent contact SYSTEM-
CONTAC
XG2600(config)# snmp agent location SYSTEM-
LOCATION
XG2600(config)# snmp agent address A.B.C.D
XG2600(config)# snmp manager 0 A.B.C.D
COMMUNIT-YNAME v2c disable
XG2600(config)# commit
XG2600(config)# save
XG2600(config)# exit
XG2600# configure
XG2600(config)# snmp service on
Command
Switch to Configuration mode.
Enable SNMP function.
Set the swith's contact (SYSTEM-CONTACT).
Set the swith's location (SYSTEM-LOCATION).
Set the SNMP agent address. This setting is also used for the local
address at trap transmission.
Make sure to set it when using the SNMP agent function
Set the IP address (host name) of the SNMP manager, the commu-
nity name, sending SNMPv2 traps, and disabling writing. if the SNMP
trap notification is enabled.
Apply the configuration.
Save the configuration.
Switch to Operation mode.
Switch to Configuration mode.
Enable SNMP function.
58
Chapter 3 Installation
Task
Workflow for Initial Setup of the Device