Serverinfo Ftp Filter - Fujitsu XG0224 User Manual

XG Series User's Guide

5.15.8.10 serverinfo ftp filter

Function
Available Model
Syntax
Options
Use Mode
Explanation
Default
Set the application filter for the FTP server function.
XG0224 / XG0448 / XG0440DC / XG0440DCR / XG2600
serverinfo ftp filter <count> <action> acl <acl_count>
<count>
• Filtering definition number
Specify a definition number, which indicates a filtering priority, with a decimal value
from 0 to 29.
A smaller value has a higher priority.
<action>
Specify an operation when filtering conditions are satisfied.
• accept
Transmit the relevant packet.
• reject
Block the relevant packet.
<acl_count>
• ACL definition number
Set the required ACL definition number with a decimal value.
If the ACL specified in <acl_count> is not set, the filtering definition will be disabled and
ignored.
The following ACL definition is available for application filtering.
- ip
Set only the source IP address and the number of mask bits.
If the ip value is not set, the filtering definition will be disabled and ignored.
- ip6
Source IPv6 address and the prefix length are used for the filter.
If IPv6 value has not been set, the filtering definition will be disabled and ignored.
Configuration mode (admin class)
Set the application filter for the FTP server function.
It is assumed that the application filter is not set for the FTP server function.
310
Chapter 5 Command Reference
Device Information Settings